![how to set up scan to email using cox cable how to set up scan to email using cox cable](https://obd2australia.com.au/wp-content/uploads/2019/12/alfa-fiat-obd2-multiecuscan-adaptor-cable-set_a.jpg)
- #How to set up scan to email using cox cable serial number
- #How to set up scan to email using cox cable tv
If the self-activation is unsuccessful, gather the Media Access Control (MAC) address ( HFC MAC ID) and the Serial number ( S/N) listed on the bottom label of the modem and contact the service provider to activate the modem. NOTE: Some service provider may allow automatic activation which will automatically launch a special website when the browser is open. Enter the address box and press the Enter key. Launch a web browser, such as Internet Explorer, Firefox, or Safari.Check with your service provider for availability in your area. * Blue - Indicates DOCSIS 3.1 operation (high-speed Internet access) which may not be available in all location. Green: Cable modem is connected to the Internet. Green: Upstream channel is connected in DOCSIS 3.0 mode.īlue*: High-speed Internet connection with upstream channels in DOCSIS 3.1 mode. Scanning for an upstream (send) channel Internet connection. Green: Downstream channel is connected in DOCSIS 3.0 mode.īlue*: High-speed Internet connection with downstream channels in DOCSIS 3.1 mode. Scanning for a downstream (receive) channel Internet connection. There may be up to one minute delay for the Power LED to light up after the power is connected. The Power, Receive, Send, and Online LEDs flash during the initial startup. Check for solid 4 LEDs on the front panel of the SB8200 cable modem.There may be up to one minute delay for the Power LED on the SB8200 cable modem front panel to light up after the power is connected. NOTE: This automatically powers ON the SB8200 cable modem. Connect the power cord to the Power port on the rear of the SB8200 cable modem and then plug it into an electrical wall outlet that is not controlled by a wall switch.From the Home screen on the printer control panel, touch the center of the gray Dashboard strip at the top of the screen and swipe the dashboard tab downward. If you already know the printers IP address, skip to step 2. If both devices cannot connect to the Internet, contact the cable provider to request an additional Internet IP address. To obtain the printers IP address, follow the steps below. However, the cable provider must provide Internet IP Address to each device for Internet access. NOTE 2: It is possible to connect two devices to the SB8200. Connecting a Wi-Fi router to the SB8200 is recommended when there are multiple client devices in the home network. Which device are you using Open the HBO Max app and then tap the Profile icon (bottom edge on phones, left edge on tablets). The LED indicator will turn from red to green.
#How to set up scan to email using cox cable tv
NOTE 1: A typical setup for Internet access consist of connecting one computer or a Wi-Fi router directly to the cable modem. If the remote does not yet control your TV Box, press and hold the SETUP button for five seconds. Connect the Ethernet cable to the Ethernet port on the computer or router and to the Ethernet port 1 on the back of the SB8200 cable modem.Hand-tighten the connectors to avoid damaging them. Connect the coaxial cable to a cable wall outlet (if not connected) and the Cable connector on the rear of the SB8200 cable modem.Coaxial (coax) cable, if one is not already connected to a cable wall outlet.